Burkert Type 2702 User Manual download pdf (Page 21)

2702 - 21

Commissioning

english

ELECTRICAL CONNECTION - TERMINALS FOR CABLE BUSHING

(TOPCONTROL TYPE 8630)

Remove the cover with the cable bushings to gain access

to the screw terminals. This is done by unscrewing the

4 self-tapping screws.

Connection PCB of the TOPControl Continuous with screw terminals and

jumpers

Terminal configuration with cable bushings

ATTENTION!

For connection to the technical earth (ground) (TE), a threaded stud with nut is provided

on the connection module. To assure electromagnetic compatibility (EMC), connect this

stud to a suitable earthing (grounding) point using as short a cable as possible

(max. 30 cm).

Use of the 4 - 20 mA setpoint input

If the voltage supply of a TOPControl Continuous device fails in a row of such devices con-

nected in series, the input of the failed device will become high-impedance. This will cause the

4 - 20 mA standard signal to fail. If this occurs, please contact Bürkert Service directly.

NOTE

Terminal Allocation External connection

Setpoint +

Setpoint GND

+ (0/4 ... 20 mA or 0 ... 5/10 V)

GND

Analog position feedback +

Analog position feedback GND

+ (0/4 ... 20 mA or 0 ... 5/10 V)

completely isolated electrically

GND

Operating voltage +

Operating voltage GND

24 V DC ± 10 %

max. residual ripple 10 %

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 93 94

No comments

Burkert Type 2702 User Manual Page 21